NOISE FILTER INSTALLATION

PROCEDURE

1. INSTALL RADIO SETTING CONDENSER

   
   

   1. 

      Attach the claw to install a 2 new terminal covers to the wire harness.

   2. Attach the clamp to temporarily install the radio setting condenser with wire harness.

   3. Install the radio setting condenser with the bolt.

      Torque:

      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

   4. Attach the 8 claws to install the terminal cover with wire harness to the radio setting condenser.

2. INSTALL RADIO SETTING CONDENSER

   
   

   1. 

      Attach the claw to install a new terminal cover to the wire harness.

   2. 

      Attach the 3 claws to install the new terminal cover with wire harness to a new radio setting condenser.

   3. Attach the clamp to temporarily install a new radio setting condenser with wire harness to the quarter.

   4. Install the new radio setting condenser with the bolt.

      Torque:

      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

3. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY

   Click here

4. INSTALL CENTER STOP LIGHT COVER

   Click here

5. INSTALL INNER ROOF SIDE GARNISH LH

   Click here

6. INSTALL INNER ROOF SIDE GARNISH RH

   Click here

7. INSTALL REAR SEAT SIDE GARNISH LH

   Click here

8. INSTALL REAR SEAT SIDE GARNISH RH

   Click here

9. INSTALL REAR DOOR SCUFF PLATE LH

   Click here

10. INSTALL REAR DOOR SCUFF PLATE RH

    Click here

11. INSTALL BENCH TYPE REAR SEATBACK ASSEMBLY

    Click here

12. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY

    Click here

13. INSTALL REAR SEAT HEADREST ASSEMBLY

    Click here

14. INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY

    Click here

15. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

16. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

17. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here

18. CHECK SEAT HEATER OPERATION (w/ Seat Heater System)

    Click here