ELECTRIC PARKING BRAKE ACTUATOR INSTALLATION

PROCEDURE


  1. APPLY HIGH-TEMPERATURE GREASE

    Click here

  2. INSTALL PARKING BRAKE WITH BRACKET ACTUATOR ASSEMBLY


    1. for Type A:

      Install the parking brake with bracket actuator assembly with the 5 nuts.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

    2. for Type B:

      Install the parking brake with bracket actuator assembly with the 4 bolts.

      Torque:
      80 N*m  { 816 kgf*cm, 59 ft.*lbf }

    3. Install the 6 parking brake cable support brackets with the 6 bolts.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

  3. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

    Click here

  4. CONNECT PARKING BRAKE CABLE

    Click here

  5. INSTALL ELECTRIC PARKING BRAKE ACTUATOR CAP


    1. for Type A:

      Install the electric parking brake actuator cap with the 2 nuts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    2. for Type B:


      1. Install the electric parking brake actuator cap with the 2 nuts.

        Torque:
        5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      2. Install the cable support bracket with the nut.

        Torque:
        5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  6. INSTALL PARKING BRAKE CABLE HEAT INSULATOR


    1. for Type B:

      Install the parking brake cable heat insulator with the 2 nuts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  7. INSTALL NO. 1 FLOOR UNDER COVER


    1. Install the No. 1 floor under cover with the 4 clips and 6 nuts.

  8. CONNECT WIRE HARNESS


    1. B002BFTE02
      Text in Illustration
      *1 Grommet
      *a Vehicle Outside
      *b Vehicle Inside

      Attach the electric parking brake actuator harness grommet.

    2. Connect the harness clamps.

    3. Connect the connector.

    4. Install the parking brake plunger protector with the bolt.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  9. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  11. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  12. ADJUST PARKING BRAKE

    Click here

    Note

    If the parking brake shoe clearance is not adjusted, the cable end may be damaged.

  13. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  14. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here

  15. INSPECT SPEED SENSOR SIGNAL

    Click here

  16. PERFORM INITIALIZATION

    Click here

  17. PERFORM PARKING BRAKE SHOE BEDDING

    Click here