BRAKE CONTROL POWER SUPPLY INSTALLATION

CAUTION / NOTICE / HINT

Note

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the driver door courtesy switch is turned on. Therefore, when servicing brake system components, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.

PROCEDURE


  1. INSTALL NO. 1 BRAKE CONTROL POWER SUPPLY BRACKET


    1. B002B59

      Slide on the 2 Mo. 1 brake control power supply brackets, and then install the brake control power supply assembly.

      Note


      • Make sure the claws are securely attached.

      • Do not drop the brake control power supply. If the brake control power supply has been dropped replace the brake control power supply with a new one.

  2. INSTALL BRAKE CONTROL POWER SUPPLY ASSEMBLY


    1. Connect the connector.

    2. Hook and the claws of the No. 1 brake control power supply bracket to the body to set it in place.

    3. B002BM6E01

      Install the brake control power supply assembly with the 2 bolts.

      Torque:
      14 N*m  { 138 kgf*cm, 10 ft.*lbf }

      Note

      Install the bolts in alphabetical order.

  3. INSTALL BENCH TYPE REAR SEATBACK ASSEMBLY

    Click here

  4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  6. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  7. CHECK AND CLEAR DTC

    Click here