TIRE PRESSURE WARNING RECEIVER(for Quarter Pillar) INSTALLATION

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

  2. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER


    1. A000R5EC01
      *a for bolt A
      *b for bolt B

      Install the tire pressure warning ECU and receiver with the bolt.

      Torque:
      for bolt A
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }
      for bolt B
      9.5 N*m  { 97 kgf*cm, 84 in.*lbf }

    2. Connect the connector.

  3. INSTALL INNER ROOF SIDE GARNISH LH

    Click here

  4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  6. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  7. REGISTER TRANSMITTER ID

    Click here

  8. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here

  9. PERFORM INITIALIZATION

    Click here