OIL PUMP MOTOR CONTROLLER INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to perform the procedure as described below. Do not turn the power switch on (READY) before the cable is connected to the negative battery terminal.

PROCEDURE


  1. INSTALL OIL PUMP MOTOR CONTROLLER


    1. Install the 2 oil pump motor controller brackets with the 3 bolts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

    2. Install the oil pump motor controller with bracket with the 2 bolts.

      Torque:
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }

  2. CONNECT WIRE HARNESS


    1. Connect the clamp.

    2. A000N6IE02
      *a Raise the lever
      *b Lock the claw
      *c Push in the lock

      Connect the connector and securely lock the lock lever as shown in the illustration.

      Note


      • Be sure to securely lock the claw of the connector.

      • Push the connector all the way in and lock the lock lever.

      Tech Tips

      When the connector is pushed all the way in, the lock lever will move slightly towards the lock position.

    3. Push the lock into the lock lever to securely lock the lock lever of the connector.

    4. Connect the connector to the oil pump motor controller.

    5. A000QB5E02
      *a Raise the lever
      *b Lock the claw
      *c Push in the lock

      Connect the connector and securely lock the lock lever as shown in the illustration.

      Note


      • Be sure to securely lock the claw of the connector.

      • Push the connector all the way in and lock the lock lever.

      Tech Tips

      When the connector is pushed all the way in, the lock lever will move slightly towards the lock position.

    6. Install the clamp to the bracket.

    7. Push the lock into the lock lever to securely lock the lock lever of the connector.

  3. INSTALL AIR CLEANER CASE

    Click here

  4. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  5. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  6. CONNECT NO. 2 VENTILATION HOSE

    Click here

  7. INSTALL NO. 1 AIR CLEANER INLET

    Click here

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here

  10. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  11. INSTALL ENGINE ROOM SIDE COVER

    Click here

  12. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  13. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here