INJECTOR DRIVER INSTALLATION

PROCEDURE


  1. INSTALL INJECTOR DRIVER

    Note


    • Be careful not to drop or strike the injector driver.

    • The injector driver is grounded at the bolt and nut. To make sure that it is grounded, clean all oil and foreign matter from the installation areas of the injector driver and engine before installing the injector driver.


    1. Install the injector driver with the bolt and 2 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
    2. A000OPFE01
      Text in Illustration
      *1 Lock Lever

      Connect the 4 connectors to the injector driver. Move the lock levers in the direction indicated by the arrow to lock the 3 connectors.

  2. INSTALL NO. 1 ENGINE COVER


    1. Install the No. 1 engine cover with the 3 clips.

  3. INSTALL NO. 1 AIR CLEANER INLET

    Click here

  4. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here

  5. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  6. INSTALL ENGINE ROOM SIDE COVER

    Click here

  7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  9. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here