ECM INSTALLATION

PROCEDURE


  1. INSTALL ENGINE ROOM ECU BOX

  2. INSTALL ENGINE ROOM ECU COVER


    1. Install the engine room ECU cover and connect the 3 claws.

  3. INSTALL NO. 2 ECM BRACKET


    1. Install the No. 2 ECM bracket with the 2 bolts.

      Torque:
      4.5 N*m  { 46 kgf*cm, 40 in.*lbf }

  4. INSTALL ECM BRACKET


    1. Install the ECM bracket with the 2 bolts.

      Torque:
      4.5 N*m  { 46 kgf*cm, 40 in.*lbf }

  5. INSTALL ECM


    1. Install the ECM with the 2 nuts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

      Note

      Any parts that have scratches, dents, etc., or that are dropped or subjected to a strong impact during servicing need to be replaced with new one.

    2. A000RD6

      Connect the 2 ECM connectors and wire clamp.

      Note


      • When connecting the connectors, make sure that dirt, water or other foreign matter does not become stuck between the connectors and other parts.

      • Make sure that the 2 levers are securely locked.

    3. for LHD:

      Connect the clamp.

    4. for RHD:

      Connect the 2 clamps.

  6. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  7. INSTALL ENGINE ROOM SIDE COVER

    Click here

  8. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  10. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  11. PERFORM INITIALIZATION

    Click here