CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly LH.
Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 screws.
Tech Tips
A new front window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH
INSTALL FRONT DOOR SERVICE HOLE COVER LH
INSTALL FRONT DOOR ARMREST SET BRACKET LH
INSTALL DOOR FRAME GARNISH LH
INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
INSTALL COURTESY LIGHT ASSEMBLY
INSTALL FRONT DOOR HOLE COVER
INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT UPPER ARMREST BASE PANEL LH (for Driver Side)
INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT UPPER ARMREST BASE PANEL RH (for Front Passenger Side)
INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL LUGGAGE COMPARTMENT TRIM COVER LH
REMOVE LUGGAGE COMPARTMENT FLOOR MAT
INITIALIZE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
CHECK POWER WINDOW