REAR SEAT OUTER BELT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL SEAT BELT RETRACTOR COVER


    1. Install the seat belt retractor cover so that the arrow on the bottom points toward the front of the vehicle.

  2. INSTALL REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH


    1. Temporarily install the rear seat 3 point type outer belt assembly LH with the 2 bolts.

    2. A000NP0N01

      Fully tighten the bolt <A> first, then the bolt <B> to install the rear seat 3 point type outer belt assembly LH.

      Torque:
      Bolt <A>
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }
      Bolt <B>
      12.5 N*m  { 127 kgf*cm, 9 ft.*lbf }

    3. Connect the connector.

    4. Connect the pretensioner connector and lock the locking button as shown in the illustration.

      Note

      Securely lock the locking button.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    5. Check if the ELR locks.

      Note

      The check should be performed with the rear seat 3 point type belt assembly installed.


      1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.

  3. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY

    Click here

  4. INSTALL INNER ROOF SIDE GARNISH LH

    Click here

  5. INSTALL INNER ROOF SIDE GARNISH RH

    Click here

  6. INSTALL REAR SEAT SIDE GARNISH LH

    Click here

  7. INSTALL REAR SEAT SIDE GARNISH RH

    Click here

  8. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

  9. INSTALL REAR DOOR SCUFF PLATE RH

    Click here

  10. INSTALL BENCH TYPE REAR SEATBACK ASSEMBLY

    Click here

  11. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY

    Click here

  12. INSTALL REAR SEAT HEADREST ASSEMBLY

    Click here

  13. INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY

    Click here

  14. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  15. INSPECT SRS WARNING LIGHT

    Click here

  16. INSPECT REAR SEAT HEATER SYSTEM (w/ Seat Heater System)

    Click here

  17. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  18. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here