ГЕНЕРАТОР СНЯТИЕ

PROCEDURE

1. REMOVE COWL TOP VENTILATOR LOUVER RH

   

   
   

   1. Remove the 6 clips and cowl top ventilator louver RH.

2. PRECAUTION

   Note

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

4. REMOVE V-BANK COVER SUB-ASSEMBLY

   Click here

5. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY

   Click here

6. REMOVE NO. 1 AIR CLEANER INLET

   Click here

7. REMOVE NO. 1 ENGINE UNDER COVER

   Click here

8. REMOVE FRONT SUSPENSION MEMBER PROTECTOR LOWER

   Click here

9. REMOVE NO. 2 ENGINE UNDER COVER

   Click here

10. REMOVE INTAKE AIR CONNECTOR PIPE

    Click here

11. REMOVE V-RIBBED BELT

    Click here

12. REMOVE GENERATOR ASSEMBLY

    

    
    

    1. Remove the nut, and disconnect the harness from the +B terminal.

    2. Disconnect the generator connector.

    3. 

       Remove the 2 bolts and 2 nuts.

    4. 

       Using an E8 "TORX" socket wrench, remove the 2 stud bolts and generator.