КАТУШКА ЗАЖИГАНИЯ И СВЕЧА ЗАЖИГАНИЯ СНЯТИЕ

PROCEDURE


  1. REMOVE COWL TOP VENTILATOR LOUVER RH

    Click here

  2. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  5. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY

    Click here

  6. REMOVE ENGINE ROOM SIDE COVER LH


    1. A001F34

      Remove the 5 clips and engine room side cover LH.

  7. REMOVE ENGINE ROOM SIDE COVER RH


    1. A001ANB

      Remove the 5 clips and engine room side cover RH.

  8. REMOVE NO. 1 AIR CLEANER INLET

    Click here

  9. REMOVE INTAKE AIR CONNECTOR PIPE


    1. A001CQB

      Disconnect the No. 1 and No. 2 ventilation hoses from the intake air connector pipe.

    2. Using a clip remover, detach the 2 wire harness clamps.

    3. Loosen the 3 hose clamps, and remove the intake air connector pipe.

  10. REMOVE BATTERY


    1. Disconnect the positive (+) battery cable from the battery terminal.

    2. A001F7Y

      Disconnect the battery cable clamp.

    3. Remove the nut, battery clamp and No. 2 battery clamp bolt.

    4. Remove the battery insulator.

    5. Remove the battery.

  11. REMOVE BATTERY TRAY


    1. A001D4C

      Remove the 3 bolts and battery tray.

  12. REMOVE SKID CONTROL ECU BRACKET

    Click here

  13. REMOVE AIR CLEANER ASSEMBLY LH

    Click here

  14. REMOVE AIR CLEANER ASSEMBLY RH

    Click here

  15. REMOVE IGNITION COIL ASSEMBLY


    1. A001E3R

      Disconnect the 8 ignition coil assembly connectors.

    2. Remove the 8 bolts.

    3. A001D88E06
      *1 Cutout

      Using a screwdriver, pry at the cutouts to remove the 8 ignition coils assemblies together with the 8 spark plug tube gaskets.

      Note

      When removing the spark plug tube gaskets, do not damage the cylinder head cover.

      Tech Tips

      Tape the screwdriver tip before use.

  16. REMOVE SPARK PLUG


    1. A001CBW

      Using a 16 mm plug wrench, remove the 8 spark plugs.