КОРПУС ДРОССЕЛЬНОЙ ЗАСЛОНКИ СНЯТИЕ

PROCEDURE


  1. REMOVE COWL TOP VENTILATOR LOUVER RH

    Click here

  2. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE V-BANK COVER SUB-ASSEMBLY

    A001D9ZE02

    1. While using both hands, lift the rear side of the cover upwards to detach the 4 clips B. Slide the cover towards the front of the vehicle to detach the 2 clips labeled A, and remove the V-bank cover sub-assembly.

      Note

      The V-bank cover sub-assembly may be damaged if its front and rear are lifted at the same time.

  5. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY

    A0018Y5E02

    1. Remove the 5 clips labeled A.

    2. Lift up the air cleaner inlet cover sub-assembly to detach the 4 clips labeled B, and remove the air cleaner inlet cover sub-assembly.

  6. REMOVE NO. 1 AIR CLEANER INLET

    A001DPZ

    1. Remove the 2 bolts.

    2. A001B3EE02
      *1 Protrusion

      Hold the No. 1 air cleaner inlet by the protrusions labeled A and labeled B, and detach the connections.

    3. Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion labeled C.

    4. Hold the air cleaner inlet by the protrusions labeled D and labeled E, and detach the connections.

    5. Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion labeled F.

  7. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  8. DRAIN ENGINE COOLANT

    Click here

  9. REMOVE INTAKE AIR CONNECTOR PIPE

    Click here

  10. REMOVE THROTTLE BODY

    A001DVQ

    1. Disconnect the throttle motor connector.

    2. Remove the 4 bolts and throttle body.

    3. A001ANT

      Slide the clamps, and disconnect the No. 4 and No. 5 water by-pass hoses from the throttle body.

    4. Remove the gasket from the intake manifold.