FRONT SEAT OUTER BELT ASSEMBLY(for 3 Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH


    1. B001I58

      Align the claw with the anchor plate positioning hole, and install the front shoulder belt anchor adjuster assembly with the 2 bolts.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Tech Tips

      First install the lower bolt, and then install the upper bolt.

  2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH

    B001FXFN03

    Note

    When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.


    1. Align the seat belt retractor positioning holes with the claws of the vehicle.

    2. Install the front seat outer belt assembly LH with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }
    3. B001DAP

      Connect the pretensioner connector as shown in the illustration.

    4. Install the shoulder anchor of the front seat outer belt assembly LH with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  3. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  4. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH


    1. Attach the 9 claws and 12 clips to install the deck trim side panel assembly LH.

    2. Install the 3 bolts and 2 screws.

    3. Install the floor anchor of the rear No. 1 seat outer belt assembly LH with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

    4. Install the floor anchor of the front seat outer belt assembly LHwith the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  5. INSTALL OUTER LAP BELT ANCHOR COVER

    Click here

  6. INSTALL FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)

    Click here

  7. INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/ o Tonneau Cover)

    Click here

  8. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

    Click here

  9. INSTALL REAR FLOOR CARPET ASSEMBLY

    Click here

  10. INSTALL QUARTER TRIM COVER HOLE LH

    Click here

  11. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  12. INSTALL MAT SET PLATE COVER

    Click here

  13. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

  14. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  15. INSTALL DOOR SCUFF PLATE ASSEMBLY LH

    Click here

  16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  17. CHECK SRS WARNING LIGHT

    Click here