REAR FLOOR AIRBAG SENSOR INSTALLATION

PROCEDURE

1. INSTALL REAR FLOOR SIDE AIRBAG SENSOR

   
   

   1. Check that the ignition switch is off.

   2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. Install the rear floor airbag sensor with the bolt.

      Torque:

      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note

      
      

      • If the rear floor airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the rear floor airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

   4. Check that the rear floor airbag sensor is not loose.

   5. Connect the connector.

2. INSTALL REAR FLOOR SIDE AIRBAG SENSOR COVER

   
   

   1. Attach the clip and claw to install the cover.

   2. Return the floor carpet to its original position.

3. INSTALL REAR DOOR SCUFF PLATE LH

   Click here

4. INSTALL REAR DOOR SCUFF PLATE RH

   Click here

5. INSTALL QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)

   Click here

6. INSTALL QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)

   Click here

7. INSTALL REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

   Click here

8. INSTALL REAR NO. 1 SEAT ASSEMBLY

   
   

   1. for 60/40 Split Double-folding Seat Type LH Side:

      
      

      1. Install the rear No. 1 seat assembly Click here.

   2. for 60/40 Split Double-folding Seat Type RH Side:

      
      

      1. Install the rear No. 1 seat assembly Click here.

   3. for 60/40 Split Tumble Seat Type LH Side:

      
      

      1. Install the rear No. 1 seat assembly Click here.

   4. for 60/40 Split Tumble Seat Type RH Side:

      
      

      1. Install the rear No. 1 seat assembly Click here.

   5. for 60/40 Split Slide Walk-in Seat Type LH Side:

      
      

      1. Install the rear No. 1 seat assembly Click here.

   6. for 60/40 Split Slide Walk-in Seat Type RH Side:

      
      

      1. Install the rear No. 1 seat assembly Click here.

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

10. CHECK SRS WARNING LIGHT

    
    

    1. Check the SRS warning light Click here.