REAR AIRBAG SENSOR(for 3 Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR AIRBAG SENSOR LH


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Install the rear airbag sensor with the nut.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that the rear airbag sensor is not loose.

    5. Connect the connector.

  2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  3. INSTALL OUTER LAP BELT COVER

    Click here

  4. INSTALL FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)

    Click here

  5. INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)

    Click here

  6. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

    Click here

  7. INSTALL REAR FLOOR CARPET ASSEMBLY

    Click here

  8. INSTALL QUARTER TRIM COVER HOLE LH

    Click here

  9. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  10. INSTALL MAT SET PLATE COVER

    Click here

  11. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

  12. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  13. INSTALL DOOR SCUFF PLATE ASSEMBLY LH

    Click here

  14. INSTALL REAR NO. 1 SEAT ASSEMBLY


    1. for 60/40 Split Double-folding Seat Type LH Side:


      1. Install the rear No. 1 seat assembly Click here.

    2. for 60/40 Split Double-folding Seat Type RH Side:


      1. Install the rear No. 1 seat assembly Click here.

    3. for 60/40 Split Tumble Seat Type LH Side:


      1. Install the rear No. 1 seat assembly Click here.

    4. for 60/40 Split Tumble Seat Type RH Side:


      1. Install the rear No. 1 seat assembly Click here.

    5. for 60/40 Split Slide Walk-in Seat Type LH Side:


      1. Install the rear No. 1 seat assembly Click here.

    6. for 60/40 Split Slide Walk-in Seat Type RH Side:


      1. Install the rear No. 1 seat assembly Click here.

  15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    CAUTION:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  16. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.