KNEE AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

   
   

   1. Check that the ignition switch is off.

   2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. 

      Connect the connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

   4. Install the airbag assembly with the 4 bolts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

   Click here

3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

   Click here

4. INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

   Click here

5. INSTALL INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

   Click here

6. INSTALL INSTRUMENT SIDE PANEL LH (for LHD)

   Click here

7. INSTALL INSTRUMENT SIDE PANEL RH (for RHD)

   Click here

8. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

9. INSTALL COWL SIDE TRIM BOARD LH (for LHD)

   Click here

10. INSTALL COWL SIDE TRIM BOARD RH (for RHD)

    Click here

11. INSTALL DOOR SCUFF PLATE ASSEMBLY LH (for LHD)

    Click here

12. INSTALL DOOR SCUFF PLATE ASSEMBLY RH (for RHD)

    Click here

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

14. CHECK SRS WARNING LIGHT

    
    

    1. Check the SRS warning light Click here.