CLEARANCE WARNING ECU(for RHD) INSTALLATION

PROCEDURE

1. INSTALL CLEARANCE WARNING ECU ASSEMBLY (for 8 Sensor Type)

   
   

   1. Install the clearance warning ECU assembly with the 2 nuts.

   2. Connect the connector.

2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (for 8 Sensor Type)

   Click here

3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for 8 Sensor Type)

   Click here

4. INSTALL INSTRUMENT PANEL ORNAMENT (for 8 Sensor Type)

   Click here

5. INSTALL INSTRUMENT SIDE PANEL LH (for 8 Sensor Type)

   Click here

6. INSTALL COWL SIDE TRIM BOARD LH (for 8 Sensor Type)

   Click here

7. INSTALL DOOR SCUFF PLATE ASSEMBLY LH (for 8 Sensor Type)

   Click here

8. INSTALL CLEARANCE WARNING ECU ASSEMBLY (for 4 Sensor Type)

   
   

   1. Install the clearance warning ECU assembly with the bolt.

   2. Connect the connector.

9. INSTALL DRIVER SIDE JUNCTION BLOCK ASSEMBLY (for 4 Sensor Type)

   
   

   1. except 5L-E:

      Click here

   2. for 5L-E:

      Click here

10. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for 4 Sensor Type)

    Click here

11. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for 4 Sensor Type)

    Click here

12. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for 4 Sensor Type)

    Click here

13. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for 4 Sensor Type)

    Click here

14. INSTALL INSTRUMENT PANEL FINISH PLATE GARNISH (for 4 Sensor Type)

    Click here

15. INSTALL INSTRUMENT SIDE PANEL RH (for 4 Sensor Type)

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

16. INSTALL COWL SIDE TRIM BOARD RH (for 4 Sensor Type)

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

17. INSTALL DOOR SCUFF PLATE ASSEMBLY RH (for 4 Sensor Type)

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for 4 Sensor Type)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

19. PERFORM DIAGNOSTIC SYSTEM CHECK (for 4 Sensor Type)

    Click here

20. CHECK SRS WARNING LIGHT (for 4 Sensor Type)

    Click here