CLEARANCE WARNING BUZZER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE DOOR SCUFF PLATE ASSEMBLY LH (for LHD)

    Click here

  4. REMOVE COWL SIDE TRIM BOARD LH (for LHD)

    Click here

  5. REMOVE INSTRUMENT SIDE PANEL LH (for LHD)

    Click here

  6. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

    Click here

  7. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

    Click here

  8. REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

    Click here

  9. REMOVE DOOR SCUFF PLATE ASSEMBLY RH (for RHD)

    Click here

  10. REMOVE COWL SIDE TRIM BOARD RH (for RHD)

    Click here

  11. REMOVE INSTRUMENT SIDE PANEL RH (for RHD)

    Click here

  12. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

    Click here

  13. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    Click here

  14. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

    Click here

  15. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  16. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY

    Click here

  17. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/o Navigation System)

    Click here

  18. REMOVE RADIO TUNER OPENING COVER (w/o Audio)

    Click here

  19. REMOVE RADIO RECEIVER ASSEMBLY (w/ Radio Receiver)

    Click here

  20. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY (w/ Navigation System)

    Click here

  21. REMOVE NO. 1 CLEARANCE WARNING BUZZER

    A01XG4H

    1. Disconnect the connector.

    2. Detach the clamp and remove the No. 1 clearance warning buzzer.