DRIVING SUPPORT SWITCH CONTROL ECU REMOVAL

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH

    Click here

  3. REMOVE COWL SIDE TRIM BOARD RH

    Click here

  4. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  5. REMOVE INSTRUMENT PANEL ORNAMENT

    Click here

  6. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  7. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  8. REMOVE DRIVING SUPPORT SWITCH CONTROL ECU

    A01XHFK

    1. Disconnect the connector.

    2. Remove the bolt and driving support switch control ECU.