4WD CONTROL ECU INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL 4 WHEEL DRIVE CONTROL ECU


    1. Install the 4 wheel drive control ECU with the bolt.

      Torque:
      12.5 N*m  { 127 kgf*cm, 9 ft.*lbf }

    2. Connect the 2 connectors.

  2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  4. INSTALL INSTRUMENT PANEL ORNAMENT

    Click here

  5. INSTALL INSTRUMENT SIDE PANEL RH

    Click here

  6. INSTALL COWL SIDE TRIM BOARD RH

    Click here

  7. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

    Click here

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.