AUTOMATIC HIGH BEAM SYSTEM PROBLEM SYMPTOMS TABLE

Tech Tips

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

Automatic High Beam System
Symptom	Suspected Area	See page
Automatic high beam indicator on the combination meter assembly does not illuminate	Check operating conditions	Click here
	Combination meter assembly	Click here
	Lane departure warning camera	Click here
	Main body ECU (Multiplex network body ECU)	Click here
Automatic high beam system does not operate	Check Data List (Auto H Beam STS)	Click here
	Low beam headlight circuit	Click here
	High beam headlight circuit	Click here
	Headlight dimmer switch circuit	Click here
	Check automatic light control system operation	Click here
	Lane departure warning camera power source circuit	Click here
	Lane departure warning camera	Click here
	Main body ECU (Multiplex network body ECU)	Click here

Tech Tips

Camera detection malfunctions can be detected using the Techstream.
Aiming misalignment of the camera can be detected using the Techstream. If the camera aiming is misaligned, check the following:

Check if the vehicle is inclined.
Check if the windshield glass is installed correctly.
Check if the lane departure warning camera is installed correctly.
Check if the lane departure warning camera is deformed.

Check if the lane departure warning camera bracket is deformed.