MAIN BODY ECU REMOVAL


  1. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY

    Click here

  2. REMOVE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    1. A01I210

      Disconnect the 5 connectors.

    2. A01I1O9

      Remove the bolt and 2 nuts, and disconnect the instrument panel junction block assembly.

    3. A01HYV7

      Disengage the claw and disconnect the connector as shown in the illustration.

    4. A01HYCJ

      Disengage the claw and release the connector lock as shown in the illustration.

    5. A01I1SV

      Disengage the claw and disconnect the connector as shown in the illustration to remove the instrument panel junction block assembly.

  3. REMOVE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)


    1. A01I1CRE01
      Text in Illustration
      *1 Main Body ECU (Multiplex Network Body ECU)
      *2 Claw of Junction Block
      *3 Protective Tape

      Press the claw of the junction block as shown in the illustration to release the lock.

    2. With the junction block lock released, insert a screwdriver with its tip wrapped with protective tape horizontally between the main body ECU (multiplex network body ECU) and junction block.

      Note

      Use a screwdriver with a diameter of between 5.0 mm (0.197 in.) and 6.3 mm (0.248 in.) and a length of approximately 90 mm (3.54 in.).

    3. A01HYZME01
      Text in Illustration
      *1 Protective Tape

      Using the screwdriver, carefully raise the main body ECU (multiplex network body ECU) up to the position where the connector becomes disengaged.

      Note

      Do not insert the screwdriver opening between the junction block and the connector of the main body ECU (multiplex network body ECU).

      Do not twist the screwdriver to raise the main body ECU (multiplex network body ECU).

    4. A01HZSXE01

      Raise the main body ECU (multiplex network body ECU) as shown by the arrow (1), and then pull it out as shown by the arrow (2) in the illustration.

      Note

      Do not touch the ECU connector.