HAZARD WARNING SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Navigation System)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY

    Click here

  4. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  5. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  6. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL (w/o Audio)

    Click here

  7. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY (w/o Audio)


    1. B001X67

      Detach the 2 claws and remove the hazard warning signal switch assembly from the center No. 1 instrument cluster finish panel.

  8. REMOVE RADIO RECEIVER ASSEMBLY (for Radio and Display Type)

    Click here

  9. REMOVE CLOCK ASSEMBLY (for Radio and Display Type (Hazard Warning Switch))


    1. B001VU9

      Remove the 2 screws and clock assembly.

  10. REMOVE MULTI-DISPLAY ASSEMBLY (w/ Navigation System (Hazard Warning Switch))


    1. B001WF1

      Remove the 2 bolts and 2 screws.

    2. B001WF5

      Pull the multi-display assembly to detach the 8 claws on the backside of the multi-display assembly and remove it.

    3. Disconnect each connector.