ANTI-LOCK BRAKE SYSTEM Skid Control Buzzer Circuit

DESCRIPTION

The skid control ECU (master cylinder solenoid) is connected to the combination meter via CAN communication.

The combination meter has a built-in buzzer.

WIRING DIAGRAM

B001XATE06
*1 Buzzer
*2 Skid Control ECU (Master Cylinder Solenoid)
*3 Combination Meter Assembly
*4 CAN Communication System

CAUTION / NOTICE / HINT

Note

After replacing the master cylinder solenoid, perform zero point calibration Click here.

PROCEDURE


  1. CHECK CAN COMMUNICATION LINE


    1. Turn the ignition switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the ignition switch to ON.

    4. Turn the GTS on.

    5. Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus.

      OK
      CAN Bus Check indicates no malfunctions in CAN communication.
      Result
      Result Proceed to
      OK A
      NG (for LHD) B
      NG (for RHD) C

    B

    GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

    C

    GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

    A

  2. PERFORM ACTIVE TEST USING GTS (BUZZER)


    1. Turn the ignition switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the ignition switch to ON.

    4. Turn the GTS on.

    5. Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

      ABS/VSC/TRC
      Tester Display Test Part Control Range Diagnostic Note
      Buzzer Buzzer Buzzer ON/OFF The buzzer can be heard.

    6. When performing the Buzzer Active Test, check Buzzer in the Data List.

      ABS/VSC/TRC
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Buzzer Buzzer/ ON or OFF

      ON: Buzzer on

      OFF: Buzzer off

      		 The combination meter has a built-in buzzer.
      Result
      Result Proceed to
      Data List Display Data List Display when Performing Active Test ON/OFF Operation
      ON Changes between ON and OFF A
      Does not change between ON and OFF B
      OFF Changes between ON and OFF A
      Does not change between ON and OFF B

    A

    GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

    B

  3. INSPECT COMBINATION METER ASSEMBLY


    1. Inspect the combination meter Click here.

      Result
      Result Proceed to
      NG (w/ Multi-information Display) A
      NG (w/o Multi-information Display) B
      OK (for LHD) C
      OK (for RHD) D

    A

    REPLACE COMBINATION METER ASSEMBLY Click here

    B

    REPLACE COMBINATION METER ASSEMBLY Click here

    C

    REPLACE MASTER CYLINDER SOLENOID Click here

    D

    REPLACE MASTER CYLINDER SOLENOID Click here