LIN COMMUNICATION SYSTEM, Diagnostic DTC:B2324

DTC Code DTC Name
B2324 Rear Door LH ECU Communication Stop

DESCRIPTION

This DTC is stored when LIN communication between the rear power window regulator motor LH and main body ECU (cowl side junction block LH) stops for 10 seconds or more.

DTC Code DTC Detection Condition Trouble Area
B2324 No communication between the rear power window regulator motor LH and main body ECU (cowl side junction block LH) for 10 seconds or more.

  • Rear power window regulator motor LH

  • Main body ECU (cowl side junction block LH)

  • Harness or connector

WIRING DIAGRAM

A01X9IPE02

CAUTION / NOTICE / HINT

Note

When using the intelligent tester with the ignition switch off to troubleshoot:

Connect the intelligent tester to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.

Tech Tips

DTC B2325 is stored when the communication between the rear power window regulator motor and main body ECU (cowl side junction block LH) stops.

PROCEDURE


  1. CLEAR DTC


    1. Clear the DTC Click here.


    NEXT

  2. CHECK FOR DTC


    1. Recheck for DTCs Click here.

      Result
      Result Proceed to
      DTC B2324 is output A
      DTC B2324 is not output B

    B

    USE SIMULATION METHOD TO CHECK Click here

    A

  3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - REAR POWER WINDOW REGULATOR MOTOR LH)

    A01WYY3E01
    *1 Front view of wire harness connector: (to Main Body ECU)
    *2 Front view of wire harness connector: (to Rear Power Window Regulator Motor LH)

    1. Disconnect the E3 ECU connector.

    2. Disconnect the J11 motor connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E3-10 (LIN2) - J11-9 (LIN) Always Below 1 Ω
      E3-10 (LIN2) or J11-9 (LIN) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. CHECK REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (BATTERY VOLTAGE AND BODY GROUND)


    1. A01X5MOE01
      *1 Front view of wire harness connector: (to Rear Power Window Regulator Motor LH)

      Disconnect the J11 motor connector.

    2. Measure the resistance and voltage according to the value(s) in the tables below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      J11-1 (GND) - Body ground Always Below 1 Ω
      Standard Voltage
      Tester Connection Condition Specified Condition
      J11-2 (B) - Body ground Always 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  5. REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    1. Temporarily replace the rear power window regulator motor LH with a new or normally functioning one Click here.

    2. Clear the DTC Click here.


    NEXT

  6. CHECK FOR DTC


    1. Recheck for DTCs Click here.

      Result
      Result Proceed to
      DTC B2324 is not output A
      DTC B2324 is output B

    A

    END (REAR POWER WINDOW REGULATOR MOTOR LH IS DEFECTIVE)

    B

    REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)