FUEL TEMPERATURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL FUEL TEMPERATURE SENSOR

    Note

    If the fuel temperature sensor is dropped, replace it with a new one.


    1. Apply a light coat of engine oil to a new O-ring.

    2. Install the O-ring to the sensor.

    3. Using SST, install the fuel temperature sensor.

      SST
      09817-33190
      Torque:
      22 N*m  { 224 kgf*cm, 16 ft.*lbf }
    4. B001VRG

      Connect the fuel temperature sensor connector.

  2. INSTALL NO. 1 AIR CLEANER PIPE SUB-ASSEMBLY

    Click here

  3. INSTALL HEATER WATER PIPE SUB-ASSEMBLY (w/ Viscous Heater)

    Click here

  4. INSTALL INTAKE AIR CONNECTOR

    Click here

  5. TEMPORARILY INSTALL NO. 1 AIR CLEANER HOSE

    Click here

  6. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  7. CONNECT WATER HOSE SUB-ASSEMBLY (w/ Viscous Heater)

  8. INSTALL NO. 2 COOL AIR INLET (w/o Intercooler)

    Click here

  9. INSTALL NO. 1 COOL AIR INLET (w/o Intercooler)

    Click here

  10. INSTALL INTERCOOLER ASSEMBLY (w/ Intercooler)

    Click here

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  12. ADD ENGINE COOLANT (w/ Viscous Heater)

    Click here

  13. INSPECT FOR COOLANT LEAK (w/ Viscous Heater)

    Click here

  14. INSTALL UPPER RADIATOR SUPPORT SEAL (w/ Viscous Heater)

    Click here

  15. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Viscous Heater)

    Click here

  16. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH (w/ Viscous Heater)

    Click here

  17. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH (w/ Viscous Heater)

    Click here