HV RELAY ASSEMBLY INSTALLATION

PROCEDURE

1. INSTALL HYBRID BATTERY JUNCTION BLOCK ASSEMBLY

   CAUTION:

   Be sure to wear insulated gloves.

   
   

   1. Install the hybrid battery junction block assembly with the 3 nuts.

      Torque:

      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

   2. Connect the 2 connectors to the hybrid battery junction block assembly.

      Note

      The connectors should be connected securely.

   3. Connect the 2 connectors to the hybrid battery junction block assembly.

2. CONNECT FRAME WIRE

   Click here

3. CHECK HIGH VOLTAGE CABLE CONNECTION

   Click here

4. INSTALL UPPER HYBRID BATTERY COVER SUB-ASSEMBLY

   Click here

5. INSTALL NO. 1 HYBRID BATTERY EXHAUST DUCT

   Click here

6. INSTALL REAR FLOOR BOARD SPACER

   Click here

7. INSTALL HV BATTERY SHIELD SHEET

   Click here

8. INSTALL REAR SEAT SIDE GARNISH RH

   Tech Tips

   Use the same procedure as for the LH side Click here.

9. INSTALL REAR DOOR SCUFF PLATE RH

   Tech Tips

   Use the same procedure as for the LH side Click here.

10. INSTALL REAR SEATBACK ASSEMBLY RH

    Click here

11. INSTALL REAR NO. 1 FLOOR BOARD

    Click here

12. INSTALL REAR NO. 2 FLOOR BOARD SUB-ASSEMBLY

    Click here

13. INSTALL REAR NO. 1 FLOOR BOARD SUB-ASSEMBLY

    Click here

14. INSTALL DECK FLOOR BOX LH (w/o Woofer)

    Click here

15. INSTALL REAR NO. 4 FLOOR BOARD (w/ Woofer)

    Click here

16. INSTALL REAR NO. 4 FLOOR BOARD (w/o Woofer)

    Click here

17. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

18. INSTALL SERVICE PLUG GRIP

    Click here