REAR SUNSHADE ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE COWL TOP VENTILATOR LOUVER

    Click here

  2. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type)

    Click here

  5. REMOVE REAR SEAT ASSEMBLY (for Power Seat)

    Click here

  6. REMOVE REAR SEAT ASSEMBLY (for 4-Passenger with Ottoman)

    Click here

  7. REMOVE REAR SEAT ASSEMBLY (for 5-Passenger with Ottoman)

    Click here

  8. REMOVE REAR DOOR SCUFF PLATE LH


    1. for Standard Body:

      Click here

    2. for Long Body:

      Click here

  9. REMOVE REAR DOOR SCUFF PLATE RH


    1. for Standard Body:

      Click here

    2. for Long Body:

      Click here

  10. REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  11. REMOVE REAR SEAT SIDE GARNISH RH

    Click here

  12. REMOVE INNER ROOF SIDE GARNISH LH

    Click here

  13. REMOVE INNER ROOF SIDE GARNISH RH

    Click here

  14. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

    A001DWI

    1. except 4-Passenger with Ottoman:

      Using a moulding remover D, detach the 4 claws and remove the 3 belt guides.

    2. for 4-Passenger with Ottoman:

      Using a moulding remover D, detach the 4 claws and remove the 2 belt guides.

    3. A001E9H

      except 4-Passenger with Ottoman:

      Detach the 2 clips of the package tray trim panel. Then pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.

    4. A001F7Z

      for 4-Passenger with Ottoman:

      Detach the 2 clips of the package tray trim panel. Then pass the 2 rear seat belt floor anchors through the package tray trim panel assembly.

    5. w/o Rear Cooler:

      Remove the package tray trim panel assembly.

    6. w/ Rear Cooler:

      Disconnect the solar sensor connector and remove the package tray trim panel assembly.

  15. REMOVE NO. 2 ROOF SIDE AIR DUCT LH (w/ Rear Cooler)

    Click here

  16. REMOVE NO. 2 ROOF SIDE AIR DUCT RH (w/ Rear Cooler)

    Click here

  17. REMOVE REAR NO. 4 AIR DUCT (w/ Rear Cooler)

    Click here

  18. REMOVE REAR NO. 5 AIR DUCT (w/ Rear Cooler)

    Click here

  19. REMOVE STEREO COMPONENT SPEAKER ASSEMBLY

    Click here

  20. REMOVE NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY

    A0019CX

    1. Detach the 5 claws and 3 clips, and remove the No. 2 package tray trim panel assembly.

  21. REMOVE REAR SUNSHADE ASSEMBLY

    A001FR3

    1. Remove the 4 bolts.

    2. Loosen the bolt labeled A and remove the rear sunshade assembly.

      Text in Illustration
      A001BDP Bolt A

      Note

      Do not remove the bolt labeled A from the rear sunshade assembly.