REAR POWER SEAT MOTOR ASSEMBLY(for Power Seat) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Before removing the rear seat, make sure to move the seat 37 mm (1.46 in.) from the rearmost position.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE COWL TOP VENTILATOR LOUVER RH

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE REAR SEAT CUSHION ASSEMBLY LH

    Click here

  5. REMOVE REAR SEAT CUSHION ASSEMBLY RH

    Click here

  6. REMOVE REAR SEATBACK ASSEMBLY LH

    Click here

  7. REMOVE REAR SEATBACK ASSEMBLY RH

    Click here

  8. REMOVE REAR NO. 2 SEAT ADJUSTER ASSEMBLY


    1. A001BUN

      Remove the nut and disconnect the anchor part of the rear center seat outer belt assembly.

    2. A001E4J

      Remove the 4 bolts, nut and rear No. 2 seat adjuster assembly.

      Note

      Be careful not to damage the vehicle body.

    3. Disconnect the air duct from the vehicle body.

  9. REMOVE REAR SEAT BELT INNER ANCHOR BRACKET ASSEMBLY LH

    Click here

  10. REMOVE SEAT CLIMATE CONTROL CONTROLLER LH

    Click here

  11. REMOVE REAR SEAT CLIMATE CONTROL BLOWER LH

    Click here

  12. REMOVE REAR NO. 1 SEAT ADJUSTER ASSEMBLY


    1. A001C5J

      Remove the 4 bolts, nut and rear No. 1 seat adjuster assembly.

      Note

      Be careful not to damage the vehicle body.

    2. Disconnect the air duct from the vehicle body.

  13. REMOVE REAR SEAT BELT INNER ANCHOR BRACKET ASSEMBLY RH

    Click here

  14. REMOVE SEAT CLIMATE CONTROL CONTROLLER RH

    Click here

  15. REMOVE REAR SEAT CLIMATE CONTROL BLOWER RH

    Click here

  16. REMOVE REAR SEAT HEADREST ASSEMBLY

    Click here

  17. REMOVE REAR SEAT HEADREST SUPPORT

    Click here

  18. REMOVE REAR NO. 1 SEAT HEADREST ADJUSTER SUB-ASSEMBLY


    1. A001EAV

      Detach the wire harness clamp and disconnect the 2 connectors.

    2. Remove the 2 bolts.

    3. Detach the 2 claws to remove the rear No. 1 seat headrest adjuster sub-assembly.

      Tech Tips

      Use the same procedure to remove the rear No. 1 seat headrest adjuster sub-assembly on the other side.

  19. REMOVE REAR SEAT SHOULDER BELT GUIDE LH

    Click here

  20. REMOVE POSITION CONTROL ECU ASSEMBLY

    Click here

  21. REMOVE REAR SEAT CLIMATE CONTROL ECU LH

    Click here

  22. REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY

    Click here

  23. REMOVE REAR SEAT COVER CAP LH

    Click here

  24. REMOVE REAR SEAT LOCK BASE LH

    Click here

  25. REMOVE REAR SEATBACK COVER WITH PAD LH

    Click here

  26. REMOVE REAR SEATBACK CLIMATE CONTROL BLOWER LH

    Click here

  27. REMOVE REAR SEAT WIRE LH


    1. A001CNZ

      Disconnect the 3 connectors.

    2. Detach the 11 wire harness clamps to remove the rear seat wire LH.

  28. REMOVE REAR SEAT SHOULDER BELT GUIDE RH

    Click here

  29. REMOVE REAR SEAT CLIMATE CONTROL ECU RH

    Click here

  30. REMOVE REAR SEAT COVER CAP RH

    Click here

  31. REMOVE REAR SEAT LOCK BASE RH

    Click here

  32. REMOVE REAR SEATBACK COVER WITH PAD RH

    Click here

  33. REMOVE REAR SEATBACK CLIMATE CONTROL BLOWER RH

    Click here

  34. REMOVE REAR SEAT WIRE RH

    Tech Tips

    Use the same procedures described for the LH side.