CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for LHD vehicles.
PROCEDURE
PRECAUTION
Note
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
REMOVE COWL TOP VENTILATOR LOUVER RH
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE REAR SEAT CUSHION ASSEMBLY LH
REMOVE REAR SEAT CUSHION ASSEMBLY RH
REMOVE REAR CENTER SEAT CUSHION ASSEMBLY (w/ Center Seat)
REMOVE REAR SEAT CONSOLE BOX (w/ Rear Console Box)
REMOVE REAR SEATBACK ASSEMBLY LH
REMOVE REAR SEATBACK ASSEMBLY RH
REMOVE REAR SEAT CENTER ARMREST ASSEMBLY (w/ Center Seat)
REMOVE REAR DOOR SCUFF PLATE LH
REMOVE REAR DOOR SCUFF PLATE RH
REMOVE REAR SEAT SIDE GARNISH LH
REMOVE REAR SEAT SIDE GARNISH RH
REMOVE INNER ROOF SIDE GARNISH LH
REMOVE INNER ROOF SIDE GARNISH RH
REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
REMOVE ROPE HOOK ASSEMBLY
REMOVE ROPE HOOK
REMOVE DECK TRIM SIDE BOARD LH
REMOVE DECK TRIM SIDE BOARD RH
REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
REMOVE NO. 2 LUGGAGE COMPARTMENT TRIM HOOK (w/o Rear Cooler)
REMOVE NO. 1 COOLER COVER (w/ Rear Cooler)
REMOVE LUGGAGE COMPARTMENT TRIM COVER SUB-ASSEMBLY FRONT
REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)
REMOVE TOOL BOX (w/o Spare Tire)
REMOVE REAR FLOOR FINISH PLATE
REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH
REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH
REMOVE ROOF SIDE NO. 2 AIR DUCT LH
REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH
REMOVE AIR HOSE
Disconnect the air hose connector.
Remove the 2 hose clamps.
Remove the bolt and 2 hose clamps.
for RHD:
Remove the bolt and hose clamp.
Detach the 2 claws and remove the air hose.