SEAT VIBRATOR MODULE ASSEMBLY(for Ottoman) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL SEAT VIBRATOR MODULE ASSEMBLY

    A001DKA

    1. Attach the claw and install the module with the 2 bolts.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    2. Connect the connector.

    3. A001DGX

      Connect the air hose connector.

  2. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH

    Click here

  3. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH

    Click here

  4. INSTALL REAR FLOOR FINISH PLATE

    Click here

  5. INSTALL TOOL BOX (w/o Spare Tire)

    Click here

  6. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

  7. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER

    Click here

  8. INSTALL NO. 1 COOLER COVER (w/ Rear Cooler)

    Click here

  9. INSTALL NO. 2 LUGGAGE COMPARTMENT TRIM HOOK (w/o Rear Cooler)

    Click here

  10. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

    Click here

  11. INSTALL DECK TRIM SIDE BOARD LH

    Click here

  12. INSTALL DECK TRIM SIDE BOARD RH

    Click here

  13. INSTALL ROPE HOOK ASSEMBLY

    Click here

  14. INSTALL ROPE HOOK

    Click here

  15. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  17. INSTALL COWL TOP VENTILATOR LOUVER

    Click here

  18. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.

  19. CHECK SEAT VIBRATION SYSTEM


    1. Check the seat vibration system Click here.