COMPRESSOR(for 2WD) REMOVAL

PROCEDURE


  1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

    Click here

  2. REMOVE COWL TOP VENTILATOR LOUVER

    Click here

  3. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

    for 1UR-FE: Click here

    for 1UR-FSE: Click here

  6. DISCONNECT SUCTION TUBE SUB-ASSEMBLY B


    1. A001FCZ

      Remove the bolt and disconnect the suction tube sub-assembly B from the with pulley compressor assembly.

    2. Remove the O-ring from the cooler refrigerant suction tube sub-assembly B.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  7. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY


    1. A0019ZE

      Remove the bolt and disconnect the discharge hose sub-assembly from the with pulley compressor assembly.

    2. Remove the O-ring from the discharge hose sub-assembly.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  8. REMOVE WITH PULLEY COMPRESSOR ASSEMBLY


    1. Disconnect the connector.

    2. A001C90

      Remove the 2 bolts and 2 nuts.

    3. Using an E8 "TORX" socket wrench, remove the 2 stud bolts and with pulley compressor assembly.