DRIVER MONITOR ECU(for LHD) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE COWL TOP VENTILATOR LOUVER RH

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE INSTRUMENT SIDE PANEL LH

    Click here

  5. REMOVE INSTRUMENT PANEL ORNAMENT

    Click here

  6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  7. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  8. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

    Click here

  9. REMOVE DRIVER MONITOR ECU ASSEMBLY


    1. A0019NJ

      Disconnect the 3 connectors.

    2. Remove the 2 nuts and ECU unit.

    3. A001DHY

      Remove the nut and driver monitor ECU assembly.