FRONT AIRBAG SENSOR INSTALLATION

PROCEDURE


  1. INSTALL FRONT AIRBAG SENSOR LH


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the battery negative (-) terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

    3. A0019LS

      Connect the connector.

    4. Install the front airbag sensor LH with the 2 bolts.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    5. Check that there is no looseness in the installation parts of the front airbag sensor.

  2. INSTALL HEADLIGHT ASSEMBLY LH

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL COWL TOP VENTILATOR LOUVER RH

    Click here

  5. CHECK SRS WARNING LIGHT

    Click here

  6. ADJUST HEADLIGHT ASSEMBLY LH

    Click here