CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH (for Standard Body)


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Temporarily install the curtain shield airbag assembly LH with 6 new bolts.

    4. Tighten the 6 bolts in the order shown in the illustration to install the curtain shield airbag assembly LH.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }
      A001DRVE04

      Note

      Do not twist the curtain shield airbag assembly LH when installing it.

    5. Install 4 new clips and then push in the 4 pins.

    6. A001E0N

      Push in the lock to connect the airbag connector.

    7. Connect the connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

  2. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH (for Long Body)


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Temporarily install the curtain shield airbag assembly LH with 6 new bolts.

    4. Tighten the 6 bolts in the order shown in the illustration to install the curtain shield airbag assembly LH.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }
      A001G0HE04

      Note

      Do not twist the curtain shield airbag assembly LH when installing it.

    5. Install 4 new clips and then push in the 4 pins.

    6. A001E0N

      Push in the lock to connect the airbag connector.

    7. Connect the connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

  3. INSTALL ROOF HEADLINING ASSEMBLY


    1. for Standard Body:

      Click here

    2. for Long Body:

      Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. CHECK SRS WARNING LIGHT

    Click here

  6. INSTALL COWL TOP VENTILATOR LOUVER RH

    Click here