FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   CAUTION:

   Be sure to read Precaution thoroughly before servicing Click here.

   Note

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

2. REMOVE COWL TOP VENTILATOR LOUVER RH

   Click here

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

   Click here

5. REMOVE INSTRUMENT SIDE PANEL RH

   Click here

6. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

7. REMOVE LOWER INSTRUMENT PANEL

   
   
   1. 

      Text in Illustration

      *1	Protective Tape

      Put protective tape around the lower instrument panel.

   2. Using a screwdriver, detach the clip and 2 claws to remove the lower instrument panel.

8. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

   
   

   1. Check that the engine switch is off.

   2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. 

      Remove the 3 bolts.

   4. Detach the claw to remove the front passenger side knee airbag assembly.

   5. Using a screwdriver release the airbag connector lock.

   6. Using a screwdriver, disconnect the airbag connector.

      Note

      When disconnecting airbag connector, take care not to damage the airbag wire harness.