BATTERY CURRENT SENSOR REMOVAL

PROCEDURE


  1. REMOVE COWL TOP VENTILATOR LOUVER

    Click here

  2. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE ENGINE ROOM SIDE COVER RH (for LHD)

    Click here

  5. REMOVE ENGINE ROOM SIDE COVER LH (for RHD)

    Click here

  6. REMOVE FRONT FENDER UPPER PROTECTOR RH (for LHD)

    Click here

  7. REMOVE FRONT FENDER UPPER PROTECTOR LH (for RHD)

    Click here

  8. REMOVE BATTERY

  9. REMOVE GROUND WIRE (BATTERY CURRENT SENSOR)


    1. A0019OZ

      for LHD:


      1. Disconnect the connector.

      2. Remove the bolt and disconnect the ground wire harness from the ground wire (battery current sensor).

      3. Remove the 2 bolts and ground wire (battery current sensor).

    2. A001B3H

      for RHD:


      1. Disconnect the connector.

      2. Remove the bolt and disconnect the ground wire harness from the ground wire (battery current sensor).

      3. Remove the 2 bolts and ground wire (battery current sensor).