NETWORK GATEWAY ECU(for LHD) REMOVAL

PROCEDURE

1. PRECAUTION

   CAUTION:

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

2. REMOVE COWL TOP VENTILATOR LOUVER RH

   Click here

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

4. REMOVE INSTRUMENT SIDE PANEL RH

   Click here

5. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

   Click here

6. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

7. REMOVE LOWER INSTRUMENT PANEL

   Click here

8. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

   Click here

9. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

   Click here

10. REMOVE NETWORK GATEWAY ECU

    
    

    1. 

       Disconnect each connector.

    2. 

       Remove the bolt, nut and No. 1 ECU integration bracket.

    3. 

       Remove the 2 nuts and network gateway ECU.