TILT AND TELESCOPIC MANUAL SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RHD and LHD.

  • The procedures listed below are for the LHD.

PROCEDURE


  1. REMOVE COWL TOP VENTILATOR LOUVER

    Click here

  2. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    1. Disable the AUTO TILT AWAY function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the AUTO TILT AWAY function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the AUTO TILT AWAY function to be disabled when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the engine switch off and disconnect the cable from the negative battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE STEERING COLUMN COVER


    1. A0019OL

      Remove the 3 screws.

      Tech Tips

      Turn the steering wheel to the right and left as necessary to remove the 2 screws.

    2. A001FS2

      Detach the 2 claws and remove the steering column lower cover.

      Note

      Do not damage the tilt and telescopic switch.

  5. REMOVE TILT AND TELESCOPIC MANUAL SWITCH


    1. Disconnect the connector.

    2. A001CRH

      Using a screwdriver, detach the claw and pull out the switch.

      Note

      Pushing on the claw too hard will break the claw.

      Tech Tips

      Tape the screwdriver tip before use.