STEERING COLUMN ASSEMBLY(for 2WD with VGRS) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering column Click here.

Tech Tips


  • Use the same procedures for the RHD and LHD.

  • The procedures listed below are for the LHD.

PROCEDURE


  1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  2. REMOVE COWL TOP VENTILATOR LOUVER

    Click here

  3. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    1. Disable the AUTO TILT AWAY function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the AUTO TILT AWAY function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the AUTO TILT AWAY function to be disabled when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the engine switch off and disconnect the cable from the negative battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  6. REMOVE STEERING COLUMN COVER (w/o Driver Monitor Camera)

    Click here

  7. REMOVE STEERING COLUMN COVER (w/ Driver Monitor Camera)

    Click here

  8. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

    Click here

  9. REMOVE NO. 1 LOWER INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  10. REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY

    Click here

  11. REMOVE STEERING SLIDING WITH SHAFT YOKE SUB-ASSEMBLY


    1. A00196PE02
      Text in Illustration
      *a Front of the vehicle

      Loosen bolt A and remove bolt B, then slide the steering sliding with shaft yoke.

      Note


      • Do not remove bolt A.

      • Do not separate the steering sliding with shaft yoke from the power steering link.

    2. A0019B9E07
      Text in Illustration
      *1 No. 2 steering intermediate shaft
      *2 Power steering link
      *a Matchmark

      Put matchmarks on the steering sliding with shaft yoke, No. 2 steering intermediate shaft and power steering link.

    3. Remove the bolt and the steering sliding with shaft yoke from the power steering link.

    4. A001CDME03
      Text in Illustration
      *1 Steering sliding with shaft yoke
      *2 No. 2 steering intermediate shaft

      Separate the steering sliding with shaft yoke from the No. 2 steering intermediate shaft.

      Tech Tips

      Insert a screwdriver or equivalent into the yoke's hole. Hold down the intermediate shaft's claw and remove the No. 2 steering intermediate shaft. If the claw is damaged, remove the claw. The intermediate shaft does not have to be replaced.

  12. REMOVE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY

    Click here

  13. REMOVE STEERING COLUMN ASSEMBLY (TILT STEERING GEAR ASSEMBLY WITH MOTOR)

    Click here