ELECTRIC PARKING BRAKE ACTUATOR INSTALLATION

PROCEDURE


  1. APPLY HIGH TEMPERATURE GREASE

    Click here

  2. INSTALL PARKING BRAKE W/BRACKET ACTUATOR ASSEMBLY


    1. A0018X7

      Install the actuator with the 3 nuts.

      Torque:
      27 N*m  { 275 kgf*cm, 20 ft.*lbf }
    2. A001EC7

      Install the 3 harness clamps to the member.

    3. A001A7Z

      Install the bolt and 5 nuts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    4. Attach the clamp to the member.

  3. CONNECT PARKING BRAKE CABLE

    Click here

  4. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

    Click here

  5. CONNECT PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

    Click here

  6. INSTALL ELECTRIC PARKING BRAKE ACTUATOR CAP


    1. A0019PL

      Connect the electric parking brake actuator cap to the body with the 2 nuts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  7. INSTALL FLOOR NO. 1 UNDER COVER

    Click here

  8. CONNECT WIRE HARNESS CLAMP

    A001D1X

    1. Install the 2 harness clamps to the electric parking brake actuator.

  9. INSTALL CONNECTOR


    1. A001C3UE03
      Text in Illustration
      *1 Grommet
      *a Vehicle Outside
      *b Vehicle Inside

      Attach the electric parking brake actuator harness grommet.

    2. A001DGF

      Connect the trunk interior's parking brake actuator connector.

  10. INSTALL REAR WHEEL HOUSE LINER LH

    Click here

  11. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH

    Click here

  12. INSTALL REAR WHEEL

    Torque:
    140 N*m  { 1428 kgf*cm, 103 ft.*lbf }

  13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  14. INSTALL COWL TOP VENTILATOR LOUVER

    Click here

  15. PERFORM INITIALIZATION

    Click here

    Note

    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

  16. ADJUST VEHICLE HEIGHT

    Click here

  17. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here

  18. INSPECT SPEED SENSOR SIGNAL

    Click here

  19. PERFORM CALIBRATION


    1. Clear the electric parking brake ECU memory and acquire tension sensor zero point Click here.

  20. ADJUST PARKING BRAKE SHOE CLEARANCE

    Click here

    Note

    If the parking brake shoe clearance is not adjusted, the cable end may be damaged.

  21. PERFORM PARKING BRAKE SHOE BEDDING

    Click here

  22. VEHICLE PREPARATION FOR HEADLIGHT AIM ADJUSTMENT

    Click here

  23. PREPARATION FOR HEADLIGHT AIMING

  24. INSPECT HEADLIGHT AIMING

    Click here

  25. ADJUST HEADLIGHT AIMING

    Click here

  26. ADJUST OBJECT RECOGNITION CAMERA

    Click here