BRAKE PEDAL SUPPORT(for LHD) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • The following procedures are for LHD vehicles.

  • For RHD vehicles, refer to the procedures for RHD vehicles Click here.

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read the Precaution thoroughly before servicing Click here.

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE COWL TOP VENTILATOR LOUVER RH

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  5. DISCONNECT CONNECTORS


    1. A001CZBE01

      Disconnect the brake pedal stroke sensor connector (labeled A).

    2. Disconnect the stop light switch connector (labeled B), and then detach the wire harness clamp (labeled C).

  6. REMOVE BRAKE PEDAL RETURN SPRING


    1. A001A29

      Remove the spring.

  7. REMOVE PUSH ROD PIN


    1. A001B3ZE01
      Text in Illustration
      *1 Push Rod Pin
      *2 Clip

      Remove the clip and push rod pin.

  8. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    1. A0018UA

      Remove the 4 nuts.

    2. A001A2FE01
      Text in Illustration
      *1 Brake Pedal Support

      Remove the 2 bolts and brake pedal support.