SKID CONTROL ECU(for LHD) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • The following procedures are for LHD vehicles.

  • For RHD vehicles, refer to the procedures for RHD vehicles Click here.

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

PROCEDURE


  1. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. REMOVE ENGINE ROOM SIDE COVER LH

    Click here

  3. REMOVE COWL TOP VENTILATOR LOUVER RH

    Click here

  4. PRECAUTION

    Note

    After turning the engine switch off, waiting time be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE SKID CONTROL ECU


    1. A001A0QE06
      Text in Illustration
      *a Front

      Disconnect the short connector for the brake stroke simulator (labeled A) from the bracket of the skid control ECU.

    2. Remove the 2 bolts (labeled B), nut (labeled C) and ECU.

    3. A001DD4E04

      Pull the 2 lock levers upward to release the locks and disconnect the 2 connectors (labeled D).

    4. Disconnect the connector (labeled E).

  7. REMOVE SKID CONTROL ECU BRACKET


    1. A0019G0E02
      Text in Illustration
      *a Front

      Remove the 2 nuts, bolt and bracket.