STEERING ANGLE SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

PROCEDURE


  1. INSTALL STEERING SENSOR


    1. A0019ZQE01
      Text in Illustration
      *1 Pin

      Align the pins on the spiral cable with the installation holes on the steering sensor.

    2. Attach the 6 claws and install the spiral cable to the steering sensor.

  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY

    Click here

  3. INSTALL STEERING COLUMN COVER


    1. w/o VGRS:

      Click here

    2. for 2WD with VGRS:

      Click here

    3. for AWD with VGRS:

      Click here

  4. ADJUST SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR

    Click here

  5. INSTALL STEERING WHEEL ASSEMBLY

    Click here

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. INSTALL COWL TOP VENTILATOR LOUVER

    Click here

  8. INSPECT STEERING PAD

    Click here

  9. CHECK SRS WARNING LIGHT

    Click here