STEERING ANGLE SENSOR REMOVAL

CAUTION / NOTICE / HINT

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read the Precaution thoroughly before servicing Click here.

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  2. REMOVE COWL TOP VENTILATOR LOUVER

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  5. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  6. REMOVE STEERING COLUMN COVER


    1. w/o VGRS:

      Click here

    2. for 2WD with VGRS:

      Click here

    3. for AWD with VGRS:

      Click here

  7. REMOVE SPIRAL CABLE SUB-ASSEMBLY

    Click here

  8. REMOVE STEERING SENSOR


    1. A001E1O

      Detach the 6 claws and remove the spiral cable.