FRONT SPEED SENSOR(for 2WD) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • The front speed sensor is a component of the front axle hub sub-assembly. If the sensor malfunctions, replace the front axle hub sub-assembly.

  • The procedures listed below are for the RH side.

  • Use the same procedures for the LH side and RH side.

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

PROCEDURE


  1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY

    Tech Tips

    The front speed sensor is a component of the front axle hub sub-assembly. If the sensor malfunctions, replace the front axle hub sub-assembly.


    1. Install the front axle hub Click here.

  2. CHECK FRONT AXLE HUB BEARING LOOSENESS

    Click here

  3. CHECK FRONT AXLE HUB RUNOUT

    Click here

  4. INSTALL FRONT DISC

    Click here

  5. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY

    Click here

  6. INSTALL SKID CONTROL SENSOR WIRE


    1. A001B7A

      Connect the connector to the front speed sensor.

    2. Install the sensor clamp with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    3. Connect the pad wear indicator connector.

    4. A00192W

      Install the 2 sensor clamps with the 2 bolts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not twist the sensor wire when installing the clamps.

    5. A001E0GE04
      Text in Illustration
      *1 Front Fender Liner

      Install the sensor clamp with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not twist the sensor wire when installing the clamp.

    6. Attach the sensor clip.

    7. Connect the sensor connector.

    8. Connect the front fender liner.

  7. INSTALL FRONT WHEEL

    Torque:
    140 N*m  { 1428 kgf*cm, 103 ft.*lbf }

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. INSTALL COWL TOP VENTILATOR LOUVER

    Click here

  10. CHECK SPEED SENSOR SIGNAL

    Click here