ECM REMOVAL

PROCEDURE


  1. REMOVE COWL TOP VENTILATOR LOUVER

    Click here

  2. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY

    Click here

  5. REMOVE ENGINE ROOM SIDE COVER LH

    Click here

  6. REMOVE ENGINE ROOM ECU COVER

    A001EJ1

    Note


    • Wipe off any water on or around the engine room ECU cover.

    • Perform these procedures in a dry place away from rain, etc.

    • Do not allow water to enter the ECM through its connectors areas, screw areas, etc.


    1. Remove the 3 bolts and engine room ECU cover.

  7. REMOVE TCM


    1. A0019VZ

      Disconnect the 4 TCM connectors.

    2. Remove the 2 nuts and TCM.

  8. DISCONNECT NO. 2 CONNECTOR HOLDER


    1. A0019L3E04
      *1 Connector Holder

      Disconnect the 2 engine wire connectors.

    2. Disconnect the 2 claws with the connector holder.

  9. REMOVE ECM


    1. A001AT9

      Disconnect the 6 ECM connectors.

    2. Remove the 2 nuts and ECM.