DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL


    1. A001F6CE02

      Using SST and a hammer, tap in a new oil seal.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )
      Standard depth
      -0.5 to 0.5 mm (-0.020 to 0.020 in.)

  2. INSTALL REAR DRIVE SHAFT ASSEMBLY LH

    Click here

  3. ADD DIFFERENTIAL OIL

    Click here

  4. CHECK DIFFERENTIAL OIL

    Click here

  5. INSTALL REAR WHEEL

    Torque:
    140 N*m  { 1428 kgf*cm, 103 ft.*lbf }

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  7. INSTALL COWL TOP VENTILATOR LOUVER


    1. for 1UR-FSE:

      Click here

    2. for 1UR-FE:

      Click here

  8. CHECK SUSPENSION CONTROL SYSTEM (for Air Suspension)

    Click here

  9. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here

  10. CHECK ABS SPEED SENSOR SIGNAL

    Click here

  11. PERFORM INITIALIZATION

    Note

    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal Click here.

  12. VEHICLE PREPARATION FOR HEADLIGHT AIMING ADJUSTMENT

    Click here

  13. PREPARATION FOR HEADLIGHT AIMING (Using a screen)

    Click here

  14. HEADLIGHT AIMING INSPECTION

    Click here

  15. HEADLIGHT AIMING ADJUSTMENT

    Click here

  16. ADJUST OBJECT RECOGNITION CAMERA

    Click here