CRUISE CONTROL MAIN SWITCH REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE COWL TOP VENTILATOR LOUVER RH

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE LOWER NO. 3 STEERING WHEEL COVER

    Click here

  5. REMOVE LOWER NO. 2 STEERING WHEEL COVER

    Click here

  6. REMOVE STEERING PAD

    Click here

  7. REMOVE CRUISE CONTROL MAIN SWITCH ASSEMBLY


    1. A001DAQ

      Remove the 2 screws.

    2. A001BNV

      Disconnect the connector and remove the cruise control main switch assembly.