STARTER(for 2WD) REMOVAL

PROCEDURE


  1. REMOVE COWL TOP VENTILATOR LOUVER

    Click here

  2. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

    Click here

  5. REMOVE NO. 3 EXHAUST MANIFOLD HEAT INSULATOR


    1. A001BLO

      Remove the 3 bolts and No. 3 exhaust manifold heat insulator.

  6. REMOVE STARTER ASSEMBLY


    1. A001EVQ

      Remove the 2 bolts and disconnect the starter assembly.

    2. A001CT8

      Open the terminal cap.

    3. Remove the 2 nuts and disconnect the starter wire.

    4. Disconnect the starter connector and remove the starter assembly.

  7. REMOVE FLYWHEEL HOUSING SIDE COVER

    A001EUX